USD
[Thermostat Controlled] Simply turn "ON" the power switch or plug in the holding tank 120V AC power cord when the outside temperature is near to freezing. Built-in Thermostat is Set to Turn Itself on at 45°F( + - 5 degrees) and Turn Itself off at 68°F( + - 5 degrees). Turn "OFF" the switch when the outside temperature remains above freezing, fluids have been vacated, or Summer is coming, or RV is not in use.
[Application] Pad size L 25'' x W 8'' works efficiently up to 50 gallon holding tanks, such as Fresh Water Tanks, Grey Water Tanks and Black Water Tanks. Please stick 2-3 pads to your tank if it larger than 50 gallons.
[Easy Installation] 2-Wires Design without plug - Convenience for fixed place installation. Just wire this pad to 12Volt DC power supply and RV power switch. Red Wire=Positive (+); White Wire=Negative (-). 3mm Foam Insulation Pad with self-adhesive make it easy installation, no extra facility required.
[High Quality Warranty] Passed US Standard QAI Quality Certification. We take full Responsibility for our products and customer dissatisfaction. One Year Warranty GUARANTEE!
Pad size (Inch): 8" x 25"
Foam Pad thickness: 3.0MM
Volts : 120 V AC
Power:84 W
Electric Current: 0.7A
Lead Wire Lengh: 36''
The 120V AC Heater pad is design to use at fixed place.
No plugin comes with the pad.
User’s Tips:
1.Do not Stretch the pad.
2.Apply tank heater pads to smooth and clean surfaces.
3.Identify the lowest point on the holding tank, closest to the drain.
4.Clean the surface of the holding tank with isopropyl alcohol and let dry.
5.Peel back the paper from the adhesive, and then press firmly and smoothly over the intended placement area.
6.Please ensure after installation the lead wires are securely located and will not hang below the surface of the tank.
7.This Model requires 120V AC to operate at maximum efficiency.
8.Please ensure the connection to the proper voltage and the proper”on/off” switch is used.
9.If two or more tank heater pads are to be used they must be connected parallel.
10.The connection must be fused with the correct amperage.
